Without -n flag, the complete list of inputs for each cell (including NULLs) is passed to the aggregate function. Individual aggregates can handle data as they choose. Mostly, they just compute the aggregate over the non-NULL values, producing a NULL result only if all inputs are NULL.
The min_raster and max_raster methods generate a map with the number of the raster map that holds the minimum/maximum value of the time-series. The numbering starts at 0 up to n for the first and the last raster listed in input=, respectively.
If the range= option is given, any values which fall outside that range will be treated as if they were NULL. The range parameter can be set to low,high thresholds: values outside of this range are treated as NULL (i.e., they will be ignored by most aggregates, or will cause the result to be NULL if -n is given). The low,high thresholds are floating point, so use -inf or inf for a single threshold (e.g., range=0,inf to ignore negative values, or range=-inf,-200.4 to ignore values above -200.4).
Linear regression (slope, offset, coefficient of determination) assumes equal time intervals. If the data have irregular time intervals, NULL raster maps can be inserted into time series to make time intervals equal (see example).
Number of raster maps to be processed is given by the limit of the operating system. For example, both the hard and soft limits are typically 1024. The soft limit can be changed with e.g. ulimit -n 1500 (UNIX-based operating systems) but not higher than the hard limit. If it is too low, you can as superuser add an entry in
/etc/security/limits.conf # <domain> <type> <item> <value> your_username hard nofile 1500
r.series input="`g.mlist pattern='insitu_data.*' sep=,`" \ output=insitu_data.stddev method=stddev
Note the g.mlist script also supports regular expressions for selecting map names.
Using r.series with NULL raster maps:
r.mapcalc "dummy = null()" r.series in=map2001,map2002,dummy,dummy,map2005,map2006,dummy,map2008 \ out=res_slope,res_offset,res_coeff meth=slope,offset,detcoeff
Example for multiple aggregates to be computed in one run (3 resulting aggregates from two input maps):
r.series in=one,two out=result_avg,res_slope,result_count meth=sum,slope,count
Example for counting the number of days above a certain temperature using daily average maps ('???' as DOY wildcard):
r.series input=`g.mlist rast pat="temp_2003_???_avg" sep=,` \ output=temp_2003_days_over_25deg range=25.0,100.0 method=count
Last changed: $Date: 2012-03-02 05:54:55 -0800 (Fri, 02 Mar 2012) $
Main index - raster index - Full index
© 2003-2012 GRASS Development Team